| So you've got your LED or Neon interior
| |
| | Positive side of the car
|
| car lights, but you're now a bit confused
| |
| | battery, or...2) It can be connected to
|
|
| |
| | any 12V power wire from under the
|
| as to where all the car interior neon
| |
| | dashboard.If you choose to tap into a
|
| lights and wires go?" Well fear not,
| |
| | power wire from behind the dash to power
|
| we'll
| |
| | your interior car lights you'll also need
|
| show all the "in's & out's" of this type
| |
| | to
|
| of installation and the easiest way of
| |
| | buy a "Circuit Tester" from your nearest
|
| doing it.It's a good idea to disconnect
| |
| | custom car accessory store - they only
|
| the battery before installing any car
| |
| | cost about $10 dollars. To use this
|
| light
| |
| | tester is simple, it looks like a pen
|
| accessories. You can do this by
| |
| | with an
|
| disconnecting the negative battery cable
| |
| | earth wire hanging out the top of it and
|
| and
| |
| | a clamp attached to the end of the
|
| placing it to one side of the battery
| |
| | wire, and it has a globe inside the
|
| where it won't touch any part of the
| |
| | middle of the pen, or on its end, which
|
| vehicles
| |
| | lights
|
| body. It's also wise to have your
| |
| | up when you have found power
|
| vehicles service manual handy for
| |
| | somewhere.To complete the interior car
|
| information
| |
| | lighting circuit - you'll now just need
|
| about the specifics of the electrical
| |
| | to
|
| system on your vehicle.For interior car
| |
| | attach the earth wire coming out from
|
| lights, the best places to mount the LED
| |
| | the from your led or neon tubes to the
|
| or neon tubes are under
| |
| | chassis of the vehicle. You can do this
|
| the dash on both sides just above where
| |
| | in the same way as described above for
|
| your feet go, but high enough so as not
| |
| | the earth wire on the tester - anywhere
|
| to kick the tubes or damage them. There
| |
| | where there is bare steel under the
|
| are also many other places you can fit
| |
| | dash is always a good earth connection
|
| them and their location is only limited
| |
| | for your interior car lights, even if you
|
| by your imagination.To operate the lights
| |
| |
|
| manually, your going to need a switch
| |
| | find a screw under the dash that is
|
| located near you,
| |
| | screwed into bare steel and it is holding
|
| so you'll need to buy a simple "2way
| |
| |
|
| toggle" switch (or use the switch that
| |
| | another wire in place as an earth, you
|
| may have came with your neon/led tube
| |
| | can use this too as an earth location.
|
| kit) from your nearest custom car
| |
| | The control panel earth wire will need
|
| accessories store. This switch will be
| |
| | to be securely screwed to the chassis of
|
| inserted into (in-line with) the main
| |
| | the vehicle
|
| power wire that supplies the kit with
| |
| | or to any "Earth wire" to complete the
|
| 12Volt power.Choose if you want your
| |
| | power circuit.After your "power" &
|
| interior car lights to turn on
| |
| | "earth" connections are complete, your
|
| automatically when the
| |
| | car interior neon
|
| headlights are turned on, or if you want
| |
| | lights should now work. If they appear
|
| to control the lights separately with a
| |
| | dull and not real bright, then be sure to
|
| "toggle" switch.If you want the neon or
| |
| |
|
| LED tubes to light up automatically when
| |
| | check that you have made GOOD earth and
|
| the headlights
| |
| | POWER connections.
|
| are turned on, then you will need to
| |
| | That's it, you're all done - now all you
|
| find a wire under the dash near the
| |
| | have to do is put any plastic panels back
|
| steering column. This wire you are
| |
| |
|
| looking for is normally Red or Yellow,
| |
| | into place that you may have removed,
|
| and it's
| |
| | pack your tools up, and then head off to
|
| supplying the "headlight control switch"
| |
| | show your friends what a great look
|
| with 12V power - you're going to have
| |
| | you've just created on your car -
|
| to "tap" into this wire to light-up your
| |
| | Enjoy!Please see our "More-In-depth" and
|
| neon lights when the headlights are
| |
| | step-by-step picture illustrated
|
| turned on.If you want to be able to
| |
| | instructions on the How to install page
|
| control the interior car lights
| |
| | listed below.Antonio Gabellone is the
|
| separately from the
| |
| | Owner/Author of - The Site is a great
|
| headlights, (best option) then there's
| |
| | resource aimed at Neon Car Lights from
|
| two ways you can do this...1) The power
| |
| | PlasmaGlow with "life-time Warranties".
|
| wire can be connected directly to the
| |
| |
|
